{"dataType":"CVE_RECORD","dataVersion":"5.2","cveMetadata":{"cveId":"CVE-2026-99746","assignerOrgId":"416baaa9-dc9f-4396-8d5f-8c081fb06d67","state":"PUBLISHED","assignerShortName":"Linux","dateReserved":"2026-09-25T10:25:14.432Z","datePublished":"2026-11-20T05:51:17.552Z","dateUpdated":"2026-11-22T11:09:58.988Z"},"containers":{"cna":{"providerMetadata":{"orgId":"416baaa9-dc9f-4396-8d5f-8c081fb06d67","shortName":"Linux","dateUpdated":"2026-11-22T11:09:58.988Z"},"descriptions":[{"lang":"en","value":"In the Linux kernel, the following vulnerability has been resolved:\n\nASoC: SOF: Intel: hda-sdw-bpt: Stop active DMA before closing BPT streams\n\nWhen sdw_enable_stream() fails in intel_ace2x_bpt_send_async() after\nhda_sdw_bpt_send_async() has already started the TX and RX DMA streams,\nintel_ace2x_bpt_close_stream() invokes hda_sdw_bpt_close() directly\nwithout calling hda_sdw_bpt_wait().  As a result,\nhda_sdw_bpt_dma_deprepare() tears down the DMA buffers and BDL while\nthe DMA hardware is still running.\n\nDisable any running TX or RX BPT DMA stream at the start of\nhda_sdw_bpt_close() before unmapping channels and depreparing DMA\nresources."}],"metrics":[{"cvssV3_1":{"version":"3.1","vectorString":"CVSS:3.1/AV:L/AC:H/PR:L/UI:N/S:U/C:H/I:H/A:H","baseScore":7,"baseSeverity":"HIGH"},"scenarios":[{"lang":"en","value":"AV:L - The patched function is hda_sdw_bpt_close(). A local user reaches it from SNDRV_CTL_IOCTL_ELEM_WRITE on the RT1320 \"DSP FW Update\" control: rt1320_dspfw_load_put() -> rt1320_dspfw_load_code() -> rt1320_data_rw() -> sdw_bpt_send_sync() -> sdw_bpt_send_async() -> generic_bpt_send_async() -> intel_ace2x_bpt_send_async(), which calls intel_ace2x_bpt_close_stream() when sdw_enable_stream() fails. request_firmware() fills the DMA buffers on the host.\nAC:H - hda_sdw_bpt_send_async() starts TX and RX DMA and sets hstream->running before sdw_enable_stream(). The buggy close runs only if that call fails. cdns_port_enable() and cdns_transport_params() always return 0; failure is a slave NACK, do_bank_switch() error, or rt1320_bus_config() -EINVAL on register 0x004d. The mixer path also enters BRA only when rt1320_dspfw_status() sees the DSP status bit clear. The attacker cannot force either condition.\nPR:L - rt1320_dspfw_load_put() is the put handler for SOC_SINGLE_EXT(\"DSP FW Update\"), registered SNDRV_CTL_ELEM_ACCESS_READWRITE with no capable() check, and snd_ctl_elem_write() invokes it for any opener of the card control device. The debugfs go file (cmd_go, mode 0200) is root-only and is the higher-privilege entry.\nUI:N - The attacking user issues SNDRV_CTL_IOCTL_ELEM_WRITE while the RT1320 DAPM bias is already SND_SOC_BIAS_OFF, the idle state checked by rt1320_dspfw_load_put().\nS:U - snd_dma_free_pages() in hda_data_stream_cleanup() releases host pages while the HDA engine and IPC4 chain DMA still address them. The impact remains host kernel memory in the same security authority.\nC:H - The playback stream started by hda_sdw_bpt_dma_enable() keeps reading dmab_tx_bdl, and the capture stream keeps writing dmab_rx_bdl, after hda_data_stream_cleanup() frees both via snd_dma_free_pages() and before chain_dma_trigger(SOF_IPC4_PIPE_RESET). Those reused pages are ordinary kernel memory, so the live DMA reads and overwrites freed kernel data.\nI:H - intel_ace2x_bpt_close_stream() calls hda_sdw_bpt_close() without hda_sdw_bpt_dma_disable(). hda_sdw_bpt_dma_deprepare() then snd_dma_free_pages() on dmab_rx_bdl while IPC4 chain DMA is still running and PPLCCTL RUN is still set; only snd_hdac_ext_stream_clear() clears that bit. The capture path writes pages the allocator can reuse.\nA:H - hda_sdw_bpt_close() reaches hda_data_stream_cleanup() without hda_sdw_bpt_dma_disable(), so chain DMA is still SOF_IPC4_PIPE_RUNNING and PPLCCTL RUN is still set when snd_dma_free_pages() drops the buffer. Continued DMA to those pages is an IOMMU fault, an oops, or a wedged HDA engine."}]}],"affected":[{"product":"Linux","vendor":"Linux","defaultStatus":"unaffected","repo":"https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git","programFiles":["sound/soc/sof/intel/hda-sdw-bpt.c"],"versions":[{"version":"4c1ce9f37d8a809dcdfba082cc9003880efa0a63","lessThan":"be6fda13447b6aaceb03a06eb5b59d132b1b2b26","status":"affected","versionType":"git"},{"version":"4c1ce9f37d8a809dcdfba082cc9003880efa0a63","lessThan":"348bc756d912dd8f47fd36c167075717951a515e","status":"affected","versionType":"git"}]},{"product":"Linux","vendor":"Linux","defaultStatus":"affected","repo":"https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git","programFiles":["sound/soc/sof/intel/hda-sdw-bpt.c"],"versions":[{"version":"6.15","status":"affected"},{"version":"0","lessThan":"6.15","status":"unaffected","versionType":"semver"},{"version":"7.3.5","lessThanOrEqual":"7.3.*","status":"unaffected","versionType":"semver"},{"version":"7.4-rc2","lessThanOrEqual":"*","status":"unaffected","versionType":"original_commit_for_fix"}]}],"cpeApplicability":[{"nodes":[{"operator":"OR","negate":false,"cpeMatch":[{"vulnerable":true,"criteria":"cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*","versionStartIncluding":"6.15","versionEndExcluding":"7.3.5"},{"vulnerable":true,"criteria":"cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*","versionStartIncluding":"6.15","versionEndExcluding":"7.4-rc2"}]}]}],"references":[{"url":"https://git.kernel.org/stable/c/be6fda13447b6aaceb03a06eb5b59d132b1b2b26"},{"url":"https://git.kernel.org/stable/c/348bc756d912dd8f47fd36c167075717951a515e"}],"title":"ASoC: SOF: Intel: hda-sdw-bpt: Stop active DMA before closing BPT streams","x_generator":{"engine":"bippy-1.2.0"}}}}