DJI AeroScope Mobile: Firmware updates are not signature-verified
Products / packages DJI AeroScope Mobile (TP703) · DJI AeroScope Mobile (TP703) 1300 communications board firmware
Published
NCSC.ch marked the affected products as already unsupported when this CVE was assigned. A patch may not be available. Review the vendor references for migration or mitigation guidance.
This tag describes support at assignment time, not current support for every related product.
Severity and exploitation
KEV coverage does not rule out exploitation.
Assessment vector
CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:H/I:H/A:HSeverity
high8.8CVSS measures technical severity, not the likelihood of an attack.
Known exploitation
Not listed in the checked CISA KEV catalog
Absence from CISA KEV does not rule out attacks.
Public exploit
Not established by this record
Missing evidence does not mean no public exploit exists.
Remediation
Source guidance available
Review the recorded instructions. Guidance may be a workaround rather than a fixed version.
What this means
DJI AeroScope Mobile firmware 03.00.00.26 and 1300 communications board firmware 02.00.07.12 through 02.00.08.40 do not verify cryptographic signatures for firmware updates, allowing an unauthenticated attacker on the local network to install modified firmware. The device must be accessible on TCP port 16000. No fixed firmware is available as the product is discontinued.
Summarized by @cf/meta/llama-3.3-70b-instruct-fp8-fast. Verify details against the original sources.Attack conditions
Exploitation requires network access to TCP port 16000 on the board and that the unit is not connected to another controlling host. NOTE: This vulnerability only affects products that are no longer supported by the maintainer.
Excerpt from the original source description below.
Review supporting sources →Affected versions
Check the exact model, release, and any platform requirements against your installation.
DJI · NCSC.ch
AeroScope Mobile (TP703)
1 range
DJI · NCSC.ch
AeroScope Mobile (TP703)
Compare with this publisher’s ranges. This does not inspect your installation.
affected
03.00.00.26
custom versions
Other versions: unknown
DJI · NCSC.ch
AeroScope Mobile (TP703) 1300 communications board firmware
1 range
DJI · NCSC.ch
AeroScope Mobile (TP703) 1300 communications board firmware
Compare with this publisher’s ranges. This does not inspect your installation.
affected
02.00.07.12 → through 02.00.08.40
custom versions
Other versions: unknown
What to do
Compare your installed product and version with the affected versions above. A matching product name alone does not confirm exposure.
DJI AeroScope Mobile has been discontinued and is no longer supported by DJI. No fixed firmware is available. Operators should plan to replace affected units with a supported product and, until then, apply the workarounds.
Connect the unit's management Ethernet port only to an isolated network segment with no untrusted hosts, and do not route or bridge that segment to other networks, so that TCP port 16000 and the multicast discovery traffic (225.0.0.37, UDP port 16001) cannot be reached. The device has no setting that enables signature checking of firmware updates.
cve.new guidance unless attributed to a publisher. This page does not inspect your installation.
Public exploit evidence
No public exploit reference is identified in the imported evidence. This is not a claim that no exploit exists.
Original source description
Read the full publisher description
Improper verification of cryptographic signature (CWE-347) in the firmware update handler of the management service (uavmonitor_usbv1) of the 1300 communications board in DJI AeroScope Mobile (TP703) firmware 03.00.00.26, with 1300 communications board firmware 02.00.07.12 through 02.00.08.40, allows an unauthenticated attacker on the local network to install modified firmware, which gives persistent code execution as root. The device accepts any image that matches an MD5 checksum supplied in the same request and does not verify a signature. Exploitation requires network access to TCP port 16000 on the board and that the unit is not connected to another controlling host. Reproduced by running the unmodified device binaries in emulation; not tested on a physical device.
NOTE: This vulnerability only affects products that are no longer supported by the maintainer. DJI has discontinued AeroScope Mobile and no fixed firmware is available.
References
3 sourcesInside the record
Evidence available
Describes the evidence in this view, not whether the product is safe.
Original records
CVE-2026-128909View the latest unmodified CVE JSON from the official source. It may be newer than this imported page.
cve.new JSON →Underlying weaknesses
The source’s classification of what caused the vulnerability.
Contributing organizations · 1
Assigning organization
Timeline
All times UTCAdvisory published
Publication date supplied by the source.
Last imported by cve.new
Latest catalog import, not the date we first saw this advisory.
What changed
Follow changesLarge field values are marked as truncated previews. Original source snapshots remain retained.